veerbeekh 0 Posted July 21, 2015 Share Posted July 21, 2015 I had a few times that their was an early termination, because of the collission of two aircrafts which didn't appeare on my list...See added file... Anyone suggestions for a solution?Kind regards, Herman Please login to display this image. Link to comment Share on other sites More sharing options...
Aerosoft Jonas S. 466 Posted July 22, 2015 Aerosoft Share Posted July 22, 2015 Hey,i will ask the developer.Jonas Link to comment Share on other sites More sharing options...
veerbeekh 0 Posted July 22, 2015 Author Share Posted July 22, 2015 Hey, That would be great, thanks!Herman Link to comment Share on other sites More sharing options...
Aerosoft Jonas S. 466 Posted July 22, 2015 Aerosoft Share Posted July 22, 2015 Can you reproduce this issue? Or did you notice any requirements for that issue to pop up?Jonas Link to comment Share on other sites More sharing options...
veerbeekh 0 Posted July 22, 2015 Author Share Posted July 22, 2015 I had two landing rwy's, two to rwy's, as shown in the photo.The time rate fastened, as seen in the picture... In this configuration I'm sure it will happen again... but I'm at work, only tonight capable of doing again... had this with multiple rwy's in charge several times at EHAM... hERMAN Link to comment Share on other sites More sharing options...
RobsonM 94 Posted July 22, 2015 Share Posted July 22, 2015 This only happened at EHAM?Please try setting peak min and max to 0. There is a slim chance that two aircraft can be spawn at the same location during peak if there is not enough entry points for the airport. If that's the case this should fix it. Link to comment Share on other sites More sharing options...
veerbeekh 0 Posted July 22, 2015 Author Share Posted July 22, 2015 Thank you Robert, this makes sense, I had the same problem at EDDM, but think that if I change peak min & max to 0 this could solve the problem. Best regards, Herman Veerbeek Link to comment Share on other sites More sharing options...
veerbeekh 0 Posted July 22, 2015 Author Share Posted July 22, 2015 Hi Robert and others,unfortunatly the error happend also with the peakthings all adjusted to 0..... Could it be that too many runways are in use? Best regards, Herman Please login to display this image. Link to comment Share on other sites More sharing options...
veerbeekh 0 Posted July 22, 2015 Author Share Posted July 22, 2015 maybe good to hold for a while.. I just discoverred the following: if I have the time rate rather quick, and make a mistake to give a line up clearance before the prior airplane has had the to clearance, they collide and disappear from screen and list... so maybe, it is just my own fault :-))) Best regards, Herman Link to comment Share on other sites More sharing options...
RobsonM 94 Posted July 24, 2015 Share Posted July 24, 2015 Well, you cannot clear two aircraft to lineup the same runway at the same time. The first one has to start it's takeoff roll Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.