Jump to content

Pitch trim wheel values


Mladen

Recommended Posts

Hi!

There is still a problem with pitch trim wheel, because there are three Zero Pitch positions:

Checked with A318 CFM and A320 CFM v1.30 E.

F/CTL Real position

-------------------------------------------

0 . 1 * UP - 0.2* UP

0 . 0 * UP - 0.1* UP

0. 0 * UP - 0.0*

0 . 0 * DN - 0.1* DN

0 . 1 * DN - 0.2* DN

This produces a problem with checklists, because if you need pitch trim of 0.8* UP and you set it to show 0.8* UP on F/CTL page on lower ECAM, the checklist will stop. For the checklist to accept 0.8* UP, you have to set trim to show 0.7* UP on F/CTL page.

Mladen

Link to comment
Share on other sites

Hi!

There is still a problem with pitch trim wheel, because there are three Zero Pitch positions:

Checked with A318 CFM and A320 CFM v1.30 E.

F/CTL Real position

-------------------------------------------

0 . 1 * UP - 0.2* UP

0 . 0 * UP - 0.1* UP

0. 0 * UP - 0.0*

0 . 0 * DN - 0.1* DN

0 . 1 * DN - 0.2* DN

This produces a problem with checklists, because if you need pitch trim of 0.8* UP and you set it to show 0.8* UP on F/CTL page on lower ECAM, the checklist will stop. For the checklist to accept 0.8* UP, you have to set trim to show 0.7* UP on F/CTL page.

Mladen

I have the same issue. Not that it makes anything unfunctional, but it's there.

Link to comment
Share on other sites

  • Deputy Sheriffs

I could reproduce it and currently we are looking into the code to find the bug......

Regards,

Rolf

Link to comment
Share on other sites

  • 5 months later...
  • Hanse unpinned this topic

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue. Privacy Policy & Terms of Use