YoYo 49 Posted May 26, 2014 Share Posted May 26, 2014 If I did check list manually I have a problem with drag chute - it isn't work in this situation. I take handle (Tail Chute Pull) near 140 kts and without any effect, no chute. I noticed than if I take "easy" quick start option (without check list and turning on all switches by hands) it works. Link to comment Share on other sites More sharing options...
wingman5 149 Posted May 26, 2014 Share Posted May 26, 2014 If I did check list manually I have a problem with drag chute - it isn't work in this situation. I take handle (Tail Chute Pull) near 140 kts and without any effect, no chute. I noticed than if I take "easy" quick start option (without check list and turning on all switches by hands) it works. Ok , thanks Yo Yo that gives me something to work on , strange though, there are no electric circuits involved Link to comment Share on other sites More sharing options...
wingman5 149 Posted May 26, 2014 Share Posted May 26, 2014 Right all ...... solution 1, in the folder "panel >> LitF3 >>" XML Lit3_load01 Open with notepad and delete the following four lines 0 (>L:chute_door,bool) 0 (>L:chute_flaps,bool) 1 (>L:chute_cap,bool) 1 (>L:chute_chute,bool) and save . if you haven't one already create a key for "reload user aircraft" and use that to replenish the chute. Meanwhile I'll try and find a better solution using shift+2. Link to comment Share on other sites More sharing options...
YoYo 49 Posted May 26, 2014 Author Share Posted May 26, 2014 Ok, good to know and thx for support. I'll test it! Link to comment Share on other sites More sharing options...
YoYo 49 Posted May 26, 2014 Author Share Posted May 26, 2014 Very good news (for me) - yep, with this small "mod" chute works now as I expect :- ).Thanks a lot. Link to comment Share on other sites More sharing options...
becas 53 Posted May 26, 2014 Share Posted May 26, 2014 You always have cracking shots YoYo! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.