Jump to content

Holding question


Recommended Posts

Hi

Let's say that my STAR has three waypoints - A, B and C.

I instruct an aircraft to enter the holding pattern at A. After one complete circuit of the hold I descend the aircraft by 1,000 feet and vector it to B where it immediately enters the holding pattern without me asking it to do this. However, I don't want it to hold at B but there is no menu option to cancel the hold and the only way that I can get the aircraft to exit the hold is by vectoring it to C where it enters the holding pattern again :mecry_s:

Is there something I am not doing correctly or is the way that GATC works?

I am using V1.1.05

Many thanks for any help.

David

Link to comment
Share on other sites

If you do not clear an aircraft past B, it hasn't got "permission" to continue past that point so it will hold. You need to clear it to a next point or on a procedure. Say past point B you have procedure "BtoDviaC", you need to clear the plane to fly just that procedure: ABC1234 J BtoDviaC

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue. Privacy Policy & Terms of Use