BAe146 NAV and STROBE lights

[cconesa 2]

I find that the NAV and STROBE lights are too far inside the wing of the aircraft (particularly the NAV lights) and are almost invisible. Looking through the AIRCRAFT.CFG file I notice that the fx-strobe wing entries, fx_navred and fx_navgre are missing. Does someone have the appropriate entries?.

Regards,

[Shaun Fletcher 570]

Hello

Back up your BAe 146-200 Eurowings Pro aircraft.cfg and copy the lights section below over the lights section in the BAe 146-200 Eurowings Pro aircraft.cfg you may see the other lights slightly but as they are built into the model they cant be removed. I'll look at the 146-300 a little later.

[lights]

//Types: 1=beacon, 2=strobe, 3=navigation, 4=cockpit, 5=landing

light.0 = 3, -6.64, -43.7, 3.6, fx_navred

light.1 = 3, -6.75, 43.6, 3.6, fx_navgre

light.2 = 1, -2.64, 1.10, -5.34, fx_beacon

light.3 = 4, 28, 0, 2.2, fx_vclight

light.4 = 2, -46.4, 0, 4.27, fx_strobe

light.5 = 2, -7, 44, 3.6, fx_strobeh

light.6 = 2, -7, -44.1, 3.6, fx_strobeh

light.7 = 2, -46.4, 0, 3.85, fx_strobe

light.8 = 3, -46.5, 0, 4.05, fx_navwhih

light.9 = 1, -0.21, 0, 7.16, fx_beacon

If you dont like them you can always go back to the original

[cconesa 2]

Thanks Shaun. Because the wings flex, the lights will be out of place until in flight. Is there a way to correct the model file?.

Regards, Christian.

[Shaun Fletcher 570]

Hello Christian,

You could try over at the the Eurowings forums here to find out if this can be done.