scox72 2 Posted September 30, 2013 Share Posted September 30, 2013 Hi,Firstly a massive thanks to Aerosoft, have updated to 1.15 then Hotfix 18 and this plane is so smooth, performance a lot better for me than 1.10.I do have one question though, I go through all phases of flight, select and confirm Appr mode on mcdu1, and land fine, but the info bar is showing select Appr mode still even after landing, am I doing something wrong?I think that this also shows along the bottom of MCDU2?SteveSent from my iPhone using Tapatalk Link to comment Share on other sites More sharing options...
Cheyenne Chief Pilot 829 Posted September 30, 2013 Share Posted September 30, 2013 To me this happens if I activate the APPR phase earlier than what the Aerosoft 'flow' suggests. When the stage is reached where Aerosoft expects me to activate APPR, the C/L system doesn't recognize it's activated already. Link to comment Share on other sites More sharing options...
cgentil 163 Posted September 30, 2013 Share Posted September 30, 2013 I can confirm bug. Link to comment Share on other sites More sharing options...
roots88 7 Posted September 30, 2013 Share Posted September 30, 2013 after flaps 1 and appr activate no flaps 2 and 3 and full i must manually flaps 2 to have the checklist landing et gear down why ????? Link to comment Share on other sites More sharing options...
Deputy Sheriffs Hanse 216 Posted October 1, 2013 Deputy Sheriffs Share Posted October 1, 2013 We found the issue and it will solved with the next hotfix / release..... Regards, Hanse Link to comment Share on other sites More sharing options...
scox72 2 Posted October 1, 2013 Author Share Posted October 1, 2013 We found the issue and it will solved with the next hotfix / release..... Regards, Hanse Hi Hanse, That's good news, is there any idea on when that may be? Steve Sent from my iPhone using Tapatalk Link to comment Share on other sites More sharing options...
Deputy Sheriffs Hanse 216 Posted October 2, 2013 Deputy Sheriffs Share Posted October 2, 2013 Hi Steve, no and if I had an idea I would not state anything. You should know that we have the policy never to state a definite date or time frame..... Regards, Hanse Link to comment Share on other sites More sharing options...
scox72 2 Posted October 3, 2013 Author Share Posted October 3, 2013 Hi Steve, no and if I had an idea I would not state anything. You should know that we have the policy never to state a definite date or time frame..... Regards, Hanse No problem Hanse, Asked more in hope than expectation lol Steve Sent from my iPhone using Tapatalk Link to comment Share on other sites More sharing options...
Deputy Sheriffs Hanse 216 Posted October 29, 2013 Deputy Sheriffs Share Posted October 29, 2013 Issue should be solved with release 1.16 ! Hanse Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.