remelco 0 Posted September 9, 2013 Share Posted September 9, 2013 Hi, In the forum I did not see something like my "problem". But correct me if I am wrong When I make the manual route between KLAX and EHAM: SEBBY7 DAG J100 NORRA J9 MLF KU72Q BOY MLS ISN J549 YBR 5400N9000W 5630N8000W 5800N7000W IRBIM 6000N5000W 6000N4000W 6100N3000W 6000N2000W 5900N1500W ERAKA UP58 SUPIT UP58 PELET UL74 VENAS UL74 TOPPA I getting this after the build option: SEBBY7 DAG J100 NORRA J9 MLF DCT BOY DCT MLS DCT ISN J549 YBR DCT ERAKA UP58 PELET UL74 TOPPA TOPA2A All waypoints are DCT. I used a route from FlightAware. Even when I used the route: SEBBY7 DAG J100 NORRA J9 MLF KU72Q BOY MLS ISN J549 YBR 54N90W 5630N80W 58N70W IRBIM 60N50W 60N40W 61N30W 60N20W 59N15W ERAKA UP58 SUPIT UP58 PELET UL74 VENAS UL74 TOPPA gives me the route as above after using the build option. The manual route is validated by the CFMU. What is going wrong? regards, Rene Link to comment Share on other sites More sharing options...
FlightSimSoft.com 283 Posted September 10, 2013 Share Posted September 10, 2013 The problem is the waypoint format: E.g. 5400N9000W should be 5400N09000W Link to comment Share on other sites More sharing options...
remelco 0 Posted September 10, 2013 Author Share Posted September 10, 2013 The problem is the waypoint format: E.g. 5400N9000W should be 5400N09000W Problem solved. Thanks Rene Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.