lamont 0 Posted February 25, 2006 Share Posted February 25, 2006 This may have been addressed before so bare with me. I've followed the tutorial and have completed sucessful flights but lately I'm not getting the full info at the end of a flight. It also seems that I have two current flights each time. This is my procedure: 1. Start FK 2. Run FSAutoStart 3. Create flight, including loading a FS flightplan 4. Start ActiveSky4.5 and load a new route for weather 5. Connect FK to FS 6. Fill-in PAX and CARGO and change TA if required 7. Obtain FK weather, decode and save 8. Minimize FK 9. Continue with flight I have set Release Parking Brakes as start time and Set Parking Brakes and Shutdown Engines as end time. If I'm doing something wrong or out of order, please let me know. Thanks Lamont Duncan COO CityLink Chief Pilot PWA VATSIM PRC Support Staff Link to comment Share on other sites More sharing options...
Thomas Molitor 24 Posted February 27, 2006 Share Posted February 27, 2006 Hi, I am sorry, but I don't get what your exact problem is. Which infos are you missing and what do you mean with "It also seems that I have two current flights each time."? Regards Thomas Link to comment Share on other sites More sharing options...
lamont 0 Posted February 27, 2006 Author Share Posted February 27, 2006 Hi Thomas, I'll try to be a bit more clear. When I finish a flight FK doesn't seem to finish. Incomplete info is flight time, fuel used, etc. If I click on disconnect it asks me if I want to abort the flight and if I say yes then another current active flight is there with all the info. This is what I meant by two flights. Just to let you know I may have solved the problem by not loading a FS flightplan in FS and manually loading a plan into FK. Perhaps doing both was causing the problem. Thanks for the reply. Lamont Duncan COO - CityLink Chief Pilot - PWA VATSIM PRC Support Staff Link to comment Share on other sites More sharing options...
Thomas Molitor 24 Posted February 27, 2006 Share Posted February 27, 2006 OK. This indicates that you are not reaching the end of flight, which means that you don't fulfill the end of flight trigger requirements (e.g. parking brakes set and engines off). This can be configured in the FSFK options (general tab). Please check that you choose the right mode for you. Hope this helps Thomas Link to comment Share on other sites More sharing options...
lamont 0 Posted February 28, 2006 Author Share Posted February 28, 2006 Hi Thomas, I have engines off, parking brake set as the end of flight trigger. I'll re-check to make sure. Thanks for the help. Link to comment Share on other sites More sharing options...
Recommended Posts