Jump to content
Sign in to follow this  
fserich

Beaver DHC2 Attitude Indicator

Recommended Posts

hi,

in the panel_early_full the attitude indicator is only working if its set to off.

setting it at on it shows "engaged" but it does not work.

can anybody help me ?

erich

Share this post


Link to post
Share on other sites
hi,

in the panel_early_full the attitude indicator is only working if its set to off.

setting it at on it shows "engaged" but it does not work.

can anybody help me ?

erich

That's a strange effect and I am not able to recreate it here. It sounds like it could be related to a setting that was loaded. Could you load the default Meigs Flight and then change to the beaver?

Share this post


Link to post
Share on other sites

hi mathijs,

i followed your instructions but it is still the same problem.

all other gauges working well except the attitude indicator.

It only works if the selector knob is set to "off" (without showing the "Engaged" label)

erich

Share this post


Link to post
Share on other sites

hi again mathijs,

first thank you very much for your replay.

i found a strange thing.

if i start with the standard DC3 the attitude indicator in the DC3 Panel is working correct. if i change the aircraft in the middle of the flight to the beaver the attitude indicator is working as well in "On" and "Off" position.

but after switching to "Off" and then to "On" again it stops working again.

Erich

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

×
×
  • Create New...