sgreen91 0 Posted December 21, 2012 Share Posted December 21, 2012 The checklists work great except on my the flights with the co-pilot. My copilot always stalls when asked "Baro Ref Cross Check" on the Approach checklist. About 2 to 3 minutes later he may or may not respond with current baro reading. I'm using AS2012 with DWC mode. Could this be the cause of the delay in reading the pressure? Sean Link to comment Share on other sites More sharing options...
Deputy Sheriffs Hanse 216 Posted December 21, 2012 Deputy Sheriffs Share Posted December 21, 2012 Hi, I think yes because we are using the FSX weather baro settings and there might be problems reading the data from other sources..... Hanse Link to comment Share on other sites More sharing options...
cbd80 258 Posted December 22, 2012 Share Posted December 22, 2012 Hi, I think yes because we are using the FSX weather baro settings and there might be problems reading the data from other sources..... Hanse I too think this may be the case, and in such an event I would try rotating the Baro knob +/- by a few digits until the correct value is matched. This should then allow the checklist to proceed. Link to comment Share on other sites More sharing options...
sgreen91 0 Posted December 22, 2012 Author Share Posted December 22, 2012 Thanks for the information. I ususally try to hit the "B" key but it seems to not change meaning its probably set correctly. The checklist finally moves on I suppose once AS2012 has finished updating the location. Thanks again for your support. Sean Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.