GustavGermano 0 Posted December 18, 2012 Share Posted December 18, 2012 Hi. The ATR don`t works when i dont from a cold start. I follow all normal procedures manual but when press START 2 pushbotton, only makes noise but the propeller not rotate, and then start noise stop. When I press the START the CL goes direct to 100% position, not to FTR. Even starting with the aircraft in operation, the FMC does not work. Nothing appears on the screen. I have XP 10.20b7. Tks. Gustavo Germano Link to comment Share on other sites More sharing options...
atgcab 2 Posted December 18, 2012 Share Posted December 18, 2012 Hi Gustavo, Do you maintain the button pressed for 5 seconds? After that, do you add fuel moving the CL to the FTR possition? If it still doesn't work it must be related to the fact that you're using a beta: 10.20b7 Regards Link to comment Share on other sites More sharing options...
GustavGermano 0 Posted December 18, 2012 Author Share Posted December 18, 2012 Hi Gustavo, Do you maintain the button pressed for 5 seconds? After that, do you add fuel moving the CL to the FTR possition? If it still doesn't work it must be related to the fact that you're using a beta: 10.20b7 Regards Hi atgcab, Tks. The START Works. But I still have the problem with the FMC. Blinks and disappears the FMC informations and the HDG / NAV / ALT and VS information on the AFCS and EFIS. Link to comment Share on other sites More sharing options...
atgcab 2 Posted December 20, 2012 Share Posted December 20, 2012 Hi atgcab, Tks. The START Works. But I still have the problem with the FMC. Blinks and disappears the FMC informations and the HDG / NAV / ALT and VS information on the AFCS and EFIS. Ok, that could be because you haven't turn on the inverters in the overhead panel. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.