Curtis Jarrett 1 Posted August 21, 2012 Share Posted August 21, 2012 I have installed and calibrated my Saitek rudder pedals as per instructions and in the FSX advanced settings have the sensitivity set to 80%, 0% null for the brakes. The problem is this: differential braking works fine. When I apply the brakes as evenly as possible I get "BRAKES", but if you move the pedals more, the "DIFFERENTIAL BRAKES" show up. It's like there is a limited range for the brakes effectiveness. Any recommendations? Thank you, Curtis Link to comment Share on other sites More sharing options...
Chaders 97 Posted August 21, 2012 Share Posted August 21, 2012 For my pedals I have 100% sensitivity with 5% null. I wouldn't worry if the Differential message shows as it's unlikely that both pedals are reporting exactly the same value to FSX. Does the aircraft actually swing? I'm pretty sure that if I stand on the brakes I'm getting full braking even if the Diff message shows. Link to comment Share on other sites More sharing options...
Curtis Jarrett 1 Posted August 21, 2012 Author Share Posted August 21, 2012 OK, thanks for your input, I'll try your recommendations. Curtis Link to comment Share on other sites More sharing options...
Snave 466 Posted August 24, 2012 Share Posted August 24, 2012 Also, check you have the reversed control function applied for the pedal brake axes in-sim. I think that also reverses the sense of the sensitivity and null zone adjustments on some setups. Link to comment Share on other sites More sharing options...
Recommended Posts