Guest Posted December 23, 2011 Share Posted December 23, 2011 Hello everyone, I am new to the forum and I have recently purchased the boxed version of Corfu X. I have some questions concerning the terrain of the island and I am wondering if anyone can answer my questions. My concern is that is it my scenery having problems or is it the way its suppose to be. Either way the scenery is awsome. I show several screenshots below that I took, thanks. NOTE: I made all settings described in the manual. I did not modifie any files. I activated the scenery in the laucher. Processor: Pentium Dual-Core CPU E5400 @ 2.70GHz 2.69GHz RAM: 3GB System: 32-bit Operating System Images: Reply or help is grealty appreciated! Matt Link to comment Share on other sites More sharing options...
KAPTEJNLN 237 Posted December 24, 2011 Share Posted December 24, 2011 well i dont think there is anything wrong as it seem the same way here as i remember and is ment to be so, if you se videos from the end of rwy 35 you se the terrain is a bit higher where the runway is located. just take a look here you can se it. Link to comment Share on other sites More sharing options...
Guest Posted December 25, 2011 Share Posted December 25, 2011 Thanks for your help, appreciated! Have a great christmas. -Matt Link to comment Share on other sites More sharing options...
EmilG 239 Posted January 3, 2012 Share Posted January 3, 2012 Thanks for your help, appreciated! Have a great christmas. -Matt Also, these transitions you see (water rise) are probably because the mesh takes some time to load. If you for example travel quickly on slew mode the FS engine cannot correctly load the terrain information in time. In normal flight however, you should not see any water elevating on the terrain, or at least much less than what you see now, and these elevations will be sharp and nice closely matching the real ones Link to comment Share on other sites More sharing options...
Guest Posted January 3, 2012 Share Posted January 3, 2012 Also, these transitions you see (water rise) are probably because the mesh takes some time to load. If you for example travel quickly on slew mode the FS engine does cannot correctly load the terrain information in time. In normal flight however, you should not see any water elevating on the terrain, or at least much less than what you see now, and these elevations will be sharp and nice closely matching the real ones Yep, its all good now. I tend to travel on slew mode to take some shots. Link to comment Share on other sites More sharing options...
Recommended Posts