jeff anisston 0 Posted February 24, 2011 Share Posted February 24, 2011 Hey. can anyone tell me what is the problem in the hyd sys?? this problem don't let me to start the engine...how can i solve this problem?? pic : Thankes!.=] Link to comment Share on other sites More sharing options...
Shaun Fletcher 570 Posted February 24, 2011 Share Posted February 24, 2011 Hello Jeff, In the "Before Start" checklist its meant to be on. In the "Engine" start did you set the JFS to START 1. This starts the Hydraulic engine as mentioned on page 25 of the manual. Link to comment Share on other sites More sharing options...
jeff anisston 0 Posted February 25, 2011 Author Share Posted February 25, 2011 Thanks but i have to mention that the problem happen in several models , but in the other models they work correctly. Thanks again. Link to comment Share on other sites More sharing options...
Shaun Fletcher 570 Posted February 25, 2011 Share Posted February 25, 2011 Hello Jeff, Did you load the default Cessna before loading the F16. Link to comment Share on other sites More sharing options...
M2769 2 Posted February 25, 2011 Share Posted February 25, 2011 It looks like your RPM is hanging at about 22%. Did you try flipping the fuel cutoff switch on the throttle (where your left pinkie would be)? From a practical standpoint, you only need to take 5 steps to start the engine from the cold and dark state (shift+2 panel): MASTER FUEL - ON, ENG FEED - NORM, Main power - PWR, JFS - START 1, then hit the fuel cutoff switch on the throttle when the RPM gets to about 20-22%. That should get your engine running. But like Shaun mentioned (at least I think this is what you were hinting at, Shaun), if you're jumping in the F-16 from another aircraft that has been shut down, that aircraft might have a switch flipped off that isn't found in the F-16 so you can't flip it back on. I have had that happen before in other aircraft, but not the F-16. Marcus Link to comment Share on other sites More sharing options...
Recommended Posts