DaveL 0 Posted February 6, 2011 Share Posted February 6, 2011 Hello, I am using TrackIR with the DHC-6 Twin Otter. I have a very difficult time getting a proper view of the autopilot. If I zoom in enough to go "through" the control yoke so I have an unobstructed straight view of the autopilot, the click points are gone. I notice this with other click points also - if zoomed in too close, the click points are gone. If I could remove the control yoke assembly from the 3D cockpit view, all would be perfect. Is this possible? If no, any suggestions to have good control of the autopilot? Thanks, Dave Link to comment Share on other sites More sharing options...
Aerosoft Aerosoft Team [Inactive Account] 51558 Posted February 6, 2011 Aerosoft Share Posted February 6, 2011 Hello, I am using TrackIR with the DHC-6 Twin Otter. I have a very difficult time getting a proper view of the autopilot. If I zoom in enough to go "through" the control yoke so I have an unobstructed straight view of the autopilot, the click points are gone. I notice this with other click points also - if zoomed in too close, the click points are gone. If I could remove the control yoke assembly from the 3D cockpit view, all would be perfect. Is this possible? If no, any suggestions to have good control of the autopilot? Thanks, Dave Sorry, it's not an object that can be removed. We are no longer in contact with the team that made the Twin Otter so a change for that s not possible. Link to comment Share on other sites More sharing options...
maddz 737 55 Posted February 6, 2011 Share Posted February 6, 2011 You could use the pop up window. Shift+ # ( its iether 3,4 or 5 ) Link to comment Share on other sites More sharing options...
Recommended Posts