bpcw001 28 Posted September 28, 2010 Share Posted September 28, 2010 Hi, please consider the following scenario: 1. Set valid frequencies for VOR/DME1 and VOR/DME2 in the MCDU 2. RMI needles show bearings to VOR1 and VOR2, and DME1/DME2 are displayed 3. Overfly one VOR (VOR1 or VOR2, doesn't matter) 4. On overflying the VOR, *both* red flags are showing up, and *both* DME displays just show "----" However, this should only happen for the VOR that is actually being overflown. Needle should not disappear, DME should not show "----" and the red flag should not show up for the VOR that is not being overflown. Regards bpcw001 Link to comment Share on other sites More sharing options...
Shaun Fletcher 570 Posted October 1, 2010 Share Posted October 1, 2010 Hello bpcw001, Is this anywhere specific or is it happening everywhere you try it! Link to comment Share on other sites More sharing options...
bpcw001 28 Posted October 1, 2010 Author Share Posted October 1, 2010 Hello bpcw001, Is this anywhere specific or is it happening everywhere you try it! I will do some more investigation and report back. Link to comment Share on other sites More sharing options...
bpcw001 28 Posted October 16, 2010 Author Share Posted October 16, 2010 I did some more flights. Regardless where in the world, when directly overflying one VOR with another one tuned in too, both red flags will show up. Hence, I think that needs to be fixed. Link to comment Share on other sites More sharing options...
Shaun Fletcher 570 Posted October 19, 2010 Share Posted October 19, 2010 Hello bpcw001, I'll mention this to the powers that be. Link to comment Share on other sites More sharing options...
Recommended Posts