Guest Dick77 Posted September 26, 2010 Share Posted September 26, 2010 In Version 1.20 the autopilot does not recognize the flightplan. Bringing the aircraft by FBW back on course and activating the AP1 does not change anything.. Has Version 1.20 another command setting in order to connect the AP with the Flightplan in the MCDU? Link to comment Share on other sites More sharing options...
cbd80 258 Posted September 26, 2010 Share Posted September 26, 2010 Hi. No there is no other command setting. Very strange. You do appear to have pushed the HDG knob for managed mode, however it can clearly be seen that it is still in select mode. Chris Link to comment Share on other sites More sharing options...
HenryD 39 Posted September 27, 2010 Share Posted September 27, 2010 There is no NAV showing on the PFD, so push the HDG button to get back into NAV mode. This happens if you AP turned off before, reengaging does not reengage NAV too. Don't know how the real aircraft handles that. Regards Henry Link to comment Share on other sites More sharing options...
Guest Dick77 Posted September 28, 2010 Share Posted September 28, 2010 Well, I have done a complete re-reinstall of FSX-Accelerate. Cleaned up the disc and defragmented it. Installed FSX, a few Aerosoft sceneries and AirbusX 1.20. Result: The AP does still not capture the routing in the flightplan, but after activating the AP the climb speed is popping up with -1800 ft/min??? and.... the new LAN-livery is also not installed. Link to comment Share on other sites More sharing options...
Recommended Posts