Jump to content

AP automatic disconnect


ChrisZet
 Share

Recommended Posts

Hi,

when i fly through bad weather conditions or turbulences, the AP sometimes automatic disconnects. I think that's like in the real Airbus (i have experienced this in the Wilco too). Is there a way to turn this off or make it not so sensitive? This is strong at longer flights when i'm not in Cockpit. In Boeing (or other) Aircraft this don't happens. I use ASE weather engine with wind/turbulence settings at middle.

Thanks,Regards

Chris

Ok, i have put down the settings in ASE wind page and have done a flight and the AP was stable. I have noticed that the AP disconnect when the weather change (through ASE update) or the wind direction change strong. Maby that's the reason.

Link to comment
Share on other sites

  • Root Admin

The AP disconnects when a strong control input is given. In development we experimented a lot with the correct setting. I do not think it can be made less sensitive.

I believe the issue starts when you encounter wind layers that are not smooth enough, a well known FSX problem. Consider using FSUIPC to smooth out the wind layers a bit.

Link to comment
Share on other sites

I believe the issue starts when you encounter wind layers that are not smooth enough, a well known FSX problem. Consider using FSUIPC to smooth out the wind layers a bit.

Yes, this was my thought. So i will set up ASE and FSUIPC again to make this shifts smoother.

Thanks, Chris

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
 Share

×
×
  • Create New...