Bleedthrough

[hotas 5]

Can somebody maybe make some things clear regarding the bleedthrough.

When i start in EHAM en taxi around everything is OK;

I take off, do some circuits en land again, the bleedthrough is back there.

I installed the rnw.file from this forum , afcadupdater V1.00 and on top V2.00.

Can anyone from Aerosoft please come up with a proper solution?

I am pretty sure this scenery has never been tested in beta.

Regards

Hotas

[Shaun Fletcher 570]

Hello Hotas,

Do you have any meshes installed or any other local scenery.

Disable all other 3rd party scenery and meshes in the scenery library then recheck the scenery.

[hotas 5]

Hello Hotas,

Do you have any meshes installed or any other local scenery.

Disable all other 3rd party scenery and meshes in the scenery library then recheck the scenery.

He Shaun, i only have VFR Netherlands installed in that area.

Could this be the reason? Strange effect is when i start in EHAM everything works fine.

Any suggestions?

Thanks

[Herman 1591]

Check to see if the DX10 preview is enabled. If so, try disabling it and see if that resolves the issue. If it does, you'll then have to decide if you can live without it when using EHAM.

[Shaun Fletcher 570]

Hello Hotas,

Dont just take it for granted that the only scenery you have in the area is the one that may be causing the problem hence my suggestion to disable it all except EHAM.

Sceneries from 1000s of miles away have been known to cause flickering like you describe.