dswo 0 Posted May 29, 2009 Share Posted May 29, 2009 When I try to prime the left engine by right-clicking the prime button (remember, right-clicking sends the button down), it jumps back up to center position. If I play with it, up and down, it will work after three or four tries, but the primer switch seems not to LIKE staying in the down/left position. Is this a bug or a feature? Link to comment Share on other sites More sharing options...
Yoda 1 Posted May 29, 2009 Share Posted May 29, 2009 If you have a wheel mouse, try using the wheel.Also, I've noticed that if you put the cursor closer to the base of the switch than the tip, it doesn't pop back to center. Link to comment Share on other sites More sharing options...
Finn 873 Posted May 30, 2009 Share Posted May 30, 2009 It's a feature In the real Cat the primer switch is springloaded.Springloaded switches though, doesn't work very well in FSX.Primers where normally only used in short 'bursts'.Finn Link to comment Share on other sites More sharing options...
dexdoggy 0 Posted June 2, 2009 Share Posted June 2, 2009 You can just hold the mouse button down too, it holds it 'till you release it. Link to comment Share on other sites More sharing options...
Recommended Posts