Can't start the engine

[D-ESBK 0]

Hello, perhaps anyone can help me please.

I try to strart F16 form Cold & Dark, but it dosent work.

I have FSX + SP2 + Acc

I Load a standard situation whiht a C172. After that i load the F16

After that I use the following start procedure :

- Electrical power switch - Power ( 2clicks forward)

- Fuel Master - On (red guard down)

- ENG Feed - Norm

- Air Source - Norm (Right side below the armrest)

- Ensure throttle is fully back (Click the Idle detent and see the throttle move forward, then clcik again to set it back again)

- Jet Fuel Starter - Start 1

- Engine spools up

- At 20 % RPM....

- Click Idle detent

- Engine should now come alive...

But this will not work on my Plane

When i click Idle detent, the RPM still at 20 %

I goot a Error Message on the F16 Display : no Pressure on Hydraulik

Can someone help my plaes.

Stephan

[VinFlyer 8]

Did you shut off the engine and all when you first loaded FS with the C172? If you do that, or with any other plane for that matter, and then change to the F-16 it won't be possible to do a working start-up. Try using the F-16 right from the start, use SHIFT+2 to select the cold-and-dark situation and it should work.

[D-ESBK 0]

Did you shut off the engine and all when you first loaded FS with the C172? If you do that, or with any other plane for that matter, and then change to the F-16 it won't be possible to do a working start-up. Try using the F-16 right from the start, use SHIFT+2 to select the cold-and-dark situation and it should work.

Thank you

your instruction fire up the engine.

Now i can fly this wonderfule plane.

Greatings form South Germany

Stephan