I have had ersearsHoneycomb Brava/Alfa for meny years. Last week I have to reinstal l MSFS2024. I have a question: Wien I try to program in, Brava, reverses, I have not:

Throttle cut. How do I program reverses. Throttle 1 and 2 No problem. I hope you can answer me fast.

Greetings

Kaare

You have already raised a support ticket for the same question.
It will be answered there.

Kåre Skorpen wrote: "I have had ersearsHoneycomb Brava/Alfa for meny years. Last week I have to reinstal l MSFS2024. I have a question: Wien I try to program in, Brava, reverses, I have not: Throttle cut. How do I program reverses. Throttle 1 and 2 No problem. I hope you can answer me fast. Greetings Kaare" Hi Kaare, In MSFS 2024 some control names have changed, so “Throttle Cut” may not appear under the same name anymore. Try searching in the controls menu for “decrease throttle” or “throttle reverse” instead, and make sure the filter is set to “All” and not only “Assigned”. For the Bravo reverser levers, you normally bind the reverse detent/buttons to either “Throttle 1 Decrease” / “Throttle 2 Decrease” or the “Hold Throttle Reverse Thrust” type command, depending on the aircraft. Also check that you are editing the Honeycomb Bravo profile, not the Alpha. If you tell me which aircraft you are setting up, I can be more specific.

Please check this tutorial.
It depicts MSFS2020 but the binding functions are the same in MSFS2024.

Bravo-A340.pdf