Jump to content

CRJ Professional Service Pack 3 (v2.5) for Lockheed Martin Prepar3D 4.5 and 5.1+

Recommended Posts

  • Administrator

CRJ Professional Service Pack 3 (v2.5) for Lockheed Martin Prepar3D 4.5 and 5.1+

- Changed ETA calculation to base on current UTC time instead of ATD
- Fixed NAV frequencies on MCDU Radio Page showing 0.0 after LOC tuned
- Fixed Coupled VNAV not initiating descent
- Limited range for PFD slip indicator
- Limited range for PFD flight director
- ETA calculation on MFD DATA FPLN Progress page
- ETA calculation on MCDU PERF INIT page 3/3
- Improvements to GPWS mode 3 (altitude loss after takeoff)
- Improvements to GPWS mode 5 (below glideslope)
- Flaps/Slats EICAS animation corrected
- Flaps/Slats exterior model animation corrected 
- Fixed wrong lbs-kg conversion in EFB ZFW input
- Added "Low cost carrier" mode for PA and FD announcements (no drinks, no coffee, no sandwiches)
- VNAV improvements. Better handling of intermediate level offs
- Fixed EFB ZFW input
- Fixed CF Leg drawing for right turns (Test case: EGHH/26 - EGHH/ILS26/BIA)
- Verified CF Leg drawing for left turns (Test case: EGHI/20 - EGHI/20/EAS)
- Last direct waypoint now disappears from DIR INTC page after the aircraft passed it.
- Fixed bearing pointers
- Fixed missing SID-Enroute transitions at end of list
- Fixed wrong heading calculation if both longitudes on a track are equal
- Added support for hardware flaps axis
- Added support for hardware spoiler axis
- Fixed ALT mode switching to ALTS CAP instead of PITCH 
- Custom Glideslope Hold
- Fixed arc and radius to fix drawing routines
- New throttle control mechanics via Simconnect
- Fixed (INTC) to Arc leg sequencing (GCFV/01 LORP4Q SID)
- Added arrow in flightplan display for arc legs (RF/AF) with the overfly flag set

Link to comment
Share on other sites

This topic is now closed to further replies.
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue. Privacy Policy & Terms of Use