GuillermoG 0 Posted October 8, 2021 Share Posted October 8, 2021 After going thru checklist and prepared flight plan, I started engine 2 with no issues. But when starting engine 1, N2 doesn't go past 25 then a message pops on EICAS saying: Left Main ejector and Left Scav Ejector. I have done all possible things but no luck. Anybody has any idea what could it be or how to resolve this issue please? Link to comment Share on other sites More sharing options...
Aerosoft Jonas S. 466 Posted October 9, 2021 Aerosoft Share Posted October 9, 2021 Hi, does this happen on ever flight? Did you try another panelstate? Could you post a screenshot of that situation? Link to comment Share on other sites More sharing options...
LesOReilly 314 Posted October 11, 2021 Share Posted October 11, 2021 2 things have been seen to cause this -- Alpha Yoke Magneto or Saitek Switch panel Magneto settings that cause an issue. The other is Mixture being assigned to a controller.... When in doubt quick check is to go into the controller settings .. make a new profile for the controller and leave everything blank.. Do this for each controller you have... Now Reload into the CRJ and use the virtual cockpit to do the engine start... does it work? Go back through your controllers and make new assignments -- or "duplicate" the original control profile and then go through it assignment by assignment and remove things that are not applicable to a JET .... like mags, Mixtures, Prop Levers etc... Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.