Oscar Lubeck 1 Posted September 30, 2021 Share Posted September 30, 2021 I have armed the CLB SPD mode as you can see, with 250kts set (video 1). The flight director isn't responding properly, forcing me to use the V/S instead. The same happens when i'm descending (video 2). The problem has taken place in the two last flights in the CRJ, never experienced it before. Is this a glitch, or have i done something wrong? Please login to view this video. Please login to view this video. Link to comment Share on other sites More sharing options...
Aerosoft Jonas S. 466 Posted October 2, 2021 Aerosoft Share Posted October 2, 2021 Hi Oscar, did you experience this issue again? Link to comment Share on other sites More sharing options...
Oscar Lubeck 1 Posted October 4, 2021 Author Share Posted October 4, 2021 Yes, i dont understand. The vertical flight director dosen't move up to climb the aircraft when im in CLB mode with a speed of 250 kts. My thrust is in the CLB detent, and the speed is increasing heavily. The pitch is still staying at 0 degrees. My Ecam memo is also blank, except of Seat Belts and No Smoking. The Ecam memo beside the engine status is totally blank also Link to comment Share on other sites More sharing options...
Oscar Lubeck 1 Posted October 4, 2021 Author Share Posted October 4, 2021 The plane is also struggeling to level off when it goes over to ALTS CAP. When i set 5000ft, it levels off at 5400ft, and stays there. Link to comment Share on other sites More sharing options...
Oscar Lubeck 1 Posted October 4, 2021 Author Share Posted October 4, 2021 Please login to view this video. Link to comment Share on other sites More sharing options...
Oscar Lubeck 1 Posted October 4, 2021 Author Share Posted October 4, 2021 Please login to view this video. Link to comment Share on other sites More sharing options...
Deputy Sheriffs Herman 1591 Posted October 4, 2021 Deputy Sheriffs Share Posted October 4, 2021 Moved to the appropriate section of the forum instead of a "No support" one. Link to comment Share on other sites More sharing options...
LesOReilly 314 Posted October 4, 2021 Share Posted October 4, 2021 @Oscar Lubeckwe can't seem to see the videos you have posted... Link to comment Share on other sites More sharing options...
Oscar Lubeck 1 Posted October 7, 2021 Author Share Posted October 7, 2021 I found the problem, no worries. It was the Honeycomb Bravo autopilot panel that disturbed the CRJ autopilot Link to comment Share on other sites More sharing options...
Deputy Sheriffs mopperle 4162 Posted October 7, 2021 Deputy Sheriffs Share Posted October 7, 2021 Because we believe this topic has been answered we have closed it. If you have any more questions feel free to open a new topic. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.