[FMS] Deleting last waypoint of a route/SID results in a "bad" course line

[KuntaKinte 210]

Another bug as stated in the title. The behaviour should be reproducible with the procedure below. It has been tested several times, so if you stick to it exactly, you should get the same results.

 

 

My setup:

Startup airport: EDDM
Aircraft state: after inital loading or after restart
FMS 2 (Copilot)): Select LEGS page (for comparison)
FMS 1 (Captain): Select FPLN page

 

ROUTE:
On FMS 1
⦁    As ORIGIN enter EDDM and EXEcute
⦁    As DEST enter EDDH and EXEcute
⦁    Select NEXT PAGE
⦁    Enter waypoint WLD  and EXEcute
⦁    Enter waypoint BURAM and EXEcute => Known bug: BURAM does not show up on the list until you put DELETE on LSK2L. This has been reported already.
⦁    Enter waypoint BOMBI and EXEcute
⦁    Select LEGS page
⦁    DELETE waypoint BOMBI and EXEcute
Result: BURAM now has a "bad" course line of 000° and a distance > 2.000 NM.

 

My setup:
as above

 

SID:
On FMS 1
⦁    As ORIGIN enter EDDM and EXEcute
⦁    As DEST enter EDDH and EXEcute
⦁    Select DEP/ARR page
⦁    Enter any SID you like and EXEcute
⦁    Select LEGS page
⦁    DELETE the last waypoint of the SID and EXEcute
Result: The waypoint before the just deleted waypoint now has a "bad" course line of 000° and a distance > 2.000 NM.

 

[KuntaKinte 210]

Dear AS Reps/Devs,

 

since you never responded to this report, I would like to know:

 

Can you confirm that

• you are able to reproduce this bug?
• this is is on your bug tracking list?