Jump to content

SWITCH OFF LED CONFIGURATION


Recommended Posts

Hi

 

My question is perhaps stupid but everybody request how switch on this LED or this other on. My question is the opposit. I would like some LED do not switch on.

In my aircraft (erj 145) there is no LED except for the MASTER and WARNING. So I would like all the other LED do no swith on on the HONEYCOMB BRAVO
After lots of time, I cannot. Could please help me.

Thank you very much for your nice help and thank you too for all your informations

Link to comment
Share on other sites

  • Aerosoft

Hi Eric,

 

I am assuming you are using the default throttle profile which is tailored to the default piston aircraft like the G1000 Cessna. So, you can check in our download section if there is a specific profile for your aircraft already available.

 

Alternatively, if everything else works as you want it to with the default throttle profile, you can also just remove the LED mappings from that one by switching into "LED-Mode", "Select LED" you want to clear and deleting their conditions using the small trash bin symbol next to them. Finally, select "Apply Changes" and the LEDs should be gone:

 

image.png 

Link to comment
Share on other sites

Hi Ben Baron

 

Thank you very much for your help

The problem is solved

The value of the anti_ice LED was not the good one for the X-Craft E145 configuration with the honneycomb Bravo.

I have change the value =0 by =1 in the cockpit2/annuciators/pitot_heat

 

Without your help, I will never find the solution

 

Best

 

Eric : A very happy customer of aerosolft

Link to comment
Share on other sites

  • Aerosoft

Thanks for your warm feedback Eric and glad you got it solved. Have fun.

 

Because we believe this topic has been answered we have closed it. If you have any more questions feel free to open a new topic.

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
 Share

×
×
  • Create New...