Jump to content

N2 stays at 25% engines shutdown/OFF condition


Recommended Posts

Hello the community,

 

When engines are not running, the N2 value stays at 25% and never goes below.

During the start sequence, immediately after pushing the start button, no need to wait for the N2 increasing value to 20% to command the fuel valve because engines are already at 25% N2.

 

I am very new with the CRJ, so I don´t know is this problem was here before the last update or not. I have tryed all start presets from the EFB.

 

Some of you have the same engine behavior?

 

2025815004_N2issue.thumb.jpg.6369a7f21630bf2bcae03a372cde99cd.jpg

Link to comment
Share on other sites

No mixture axis assign on my throttle. I didn´t find any topic about this same event on the forum.

 

It´s like if the Starter Motor was everytime running, like a Crank who never stop.

Link to comment
Share on other sites

Hi! ONce you press start I do expect N2 raises up and then waits up for you having throttles in idle to advance the start phase. Am I wrong or do I have wrongly got your exact "situation"?

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
 Share

×
×
  • Create New...