Freighthlr 0 Posted April 3, 2021 Share Posted April 3, 2021 I purchased the DC-8 series 3.0v 04/02/2121. Current install FSX SP1 &2. There were no issues with the installation. However, was unable to activate ext pwr. Searched the forum and found a download link that would replace the Ground Interface XMl editor. That resolved the external power issue. During a test flight (minimal fuel and no cargo) takeoff and climb the exterior scenery was vibrating. Aircraft pitched down even though properly balanced %C/G. Using trim to correct does not correspond as it should, although these adjustments will eventually have effect, the aircraft will then react by climbing at an incredible rate. Very hard to stabilize. All of this is hands on flying during climb out. No AP or outside weather programs involved. I have no issues with my joystick. Engine startup sounds NOTHING like that of a 50 series. I spent a lot of time in these aircraft, as well as the 60 and 70 series. I am really frustrated and disappointed. Link to comment Share on other sites More sharing options...
Freighthlr 0 Posted April 12, 2021 Author Share Posted April 12, 2021 It appears support is non existent. Link to comment Share on other sites More sharing options...
Deputy Sheriffs mopperle 4162 Posted April 12, 2021 Deputy Sheriffs Share Posted April 12, 2021 Please stick to you other post in the correct forum. Unfortunately I do not have any experience with this aircraft, so I cant help. But you can also open a ticket at support@aerosoft.com Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.