Jump to content

left engine doesn't start after CRJ update


Patrick Paris 75

Recommended Posts

Hello 

Qince the last CRJ update, the left engine doesn't start.

Before update everything was working very well.

I reseted the CRJ file in FS2020,  started and closed the sim; downloadede fresh zip from aerosoft site... nothing helps.

here is a picture 

Please login to display this image.

Link to comment
Share on other sites

15 minutes ago, Patrick Paris 75 said:

Hello 

Qince the last CRJ update, the left engine doesn't start.

Before update everything was working very well.

I reseted the CRJ file in FS2020,  started and closed the sim; downloadede fresh zip from aerosoft site... nothing helps.

here is a picture 

Please login to display this image.

Can you unarm the left reverser and try again? Just guessing here. 

Link to comment
Share on other sites

had the same problem once yesterday. i then tried to reset the plane to "ready for taxi" and got this result then:

 

Please login to display this image.

 

apart from the fadec faults i've not seen before yet, i tried to shut both engines down. the right one still behaved as expected but the left one was fully unresponsive and just stayed running. i restarted the game then.

Link to comment
Share on other sites

Again there are more bugs with the engine start :

 

1. When starting the sim on ramp : the CRJ loads with engines running.

2. when switching to Cold and Dark status >> engines shut down but N2 remain at 25 and N1 at 17.  therefore the manual startup is not possible

The only way I found  to start the engines is CTRL +E

very annoying 

All these issues were not present with the native version.

 

Hope aerosoft will take this issue in mind and process to some correcting patch. It seems thbey had exazctly the sazme issue with previous versions with P3D/FSX CRJ

Link to comment
Share on other sites

SOLVED  ---

++++If you are using the Honeycomb alpha yoke ++++ >> 

YOU MUST TURN OFF THE STARTER  at the left side of the yoke ...

this was the cause of all the bugs ----

then the engines will start manually wthout issue.

:_))

Link to comment
Share on other sites

I had the same problem. A close look at  the settings of the bravo throttle qudrant showed a binding of "joystick button" 28 and 33 with "decrease mixture 1" asnd "decrease mixture 2" respectively. After deleting  both bindings, everything worked fine.

Link to comment
Share on other sites

  • Aerosoft
15 hours ago, dcthus said:

I had the same problem. A close look at  the settings of the bravo throttle qudrant showed a binding of "joystick button" 28 and 33 with "decrease mixture 1" asnd "decrease mixture 2" respectively. After deleting  both bindings, everything worked fine.

 

Indeed, it basically has to be assignment issue.

Link to comment
Share on other sites

  • Deputy Sheriffs

Because we believe this topic has been answered we have closed it. If you have any more questions feel free to open a new topic.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue. Privacy Policy & Terms of Use