Engines not fully shut down (N2 and N1)

[awilks01 0]

Hello,

 

I am having an issue no matter what state I am in when I have the engines off or shut them down, my N2 stays at 25% and N1 at 3%. I have used the fix from below and there is no avail so far. Looking for some guidance.

 

Quote from previous thread

 

"First of all from someone type rated in the aircraft great job recreating the aircraft. For me the N2 of both engines is going no lower then 25% and the N1 3% when parked at the gate with both engines off. APU is off both start valves are closed and fuel flow is 0. It seems like something in the logic of the plane or sim is stuck in a process of constantly trying to start both engines. N2 will only move when during a start as the thrust lever is moved out of the cutoff position. From that point on, the N2 and all other engine parameters will behave as expected until shutdown when the frozen N2 and N1 behavior returns."

 

"Update. Cleared out all engine commands from the switches on my throttle quadrant. That cleared the issue. Feel free to close."

[Matthew2312 95]

Check all of your controls including keyboard yoke and rudder pedals and delete anything that has to do with engine control other then your thrust levers. There were some pretty obscure ones for me.