august78 5 Posted March 17, 2021 Share Posted March 17, 2021 https://imgur.com/3Saq8da This image shows me doing a direct-to Osval. it is blue in the fmc, but in the PFD says next waypoint is insap. The plane is no longer tracking the lines on the ND. Link to comment Share on other sites More sharing options...
simone guanziroli 14 Posted March 17, 2021 Share Posted March 17, 2021 me too. PRoblems with direct. When I do direct the route not start from the plane but with a offset Please login to display this image. Please login to display this image. Link to comment Share on other sites More sharing options...
august78 5 Posted March 18, 2021 Author Share Posted March 18, 2021 Any advice or feedback from Aerosoft on this issue? Link to comment Share on other sites More sharing options...
Deputy Sheriffs Secondator 643 Posted March 18, 2021 Deputy Sheriffs Share Posted March 18, 2021 I'll have a look into this tomorrow. Link to comment Share on other sites More sharing options...
JuiceBox7535 19 Posted March 19, 2021 Share Posted March 19, 2021 @august78, looking at the legs page, it appears the active leg in the FMC is OSVAL > INSAP (OSVAL is in the blue colored "from" line). In other words, not present position direct to OSVAL. In that case, I would press the top left line select key to copy OSVAL, and then the next line select key down to paste it into the magenta "to" line. Then hit execute. (going off memory and am away from my PC, so hopefully the sim allows you to copy the from waypoint like it should). Hard to say what caused that, but hopefully that helps. @simone guanziroli What method are you using to go direct to KUMBI? If you paste KUMBI into the 2nd line select key (magenta "to" line) and hit execute, does it sync up your course? Or are you using the DIR INTC key on the FMC? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.