DWadsworth 1 Posted March 14, 2021 Share Posted March 14, 2021 I have been unable to setup the throttles on my BTQ. Using the P3D axis assignment and calibration (FSUIPC tried also) results in the throttles not moving or responding. Using the Throttle calibration tool in CRJ pegs high/low after first motion, and then does not respond at all. CRJ has to be reloaded. MS tools shows nominal operations of the axes. Other aircraft throttles behave as expected. I've exhaustedly tried all configuration combinations in CRJ, FSUIPC, and P3D. Any suggestions? Link to comment Share on other sites More sharing options...
Aerosoft SimWare 730 Posted March 15, 2021 Aerosoft Share Posted March 15, 2021 Dear Sir, A couple of questions and things to try : - Can you please first make a basic calibration of the BTQ in the Windows joystick utility ? (Check the "Display raw data" box and look for any unusal readings.) - Please make sure nothing is still assigned in FSUIPC for the throttle. If you see nothing but suspect is could be the case annyway, you can temporary move the "Module" folder containing the FSUIPC files somewhere else during tests. This is to be tried last) - Please also check that no other device (yoke, rudder,... has any default assignment to the throttle as the CRJ wouldn't know then what signal to consider. - Can you send us : 1 - A screenshot of the throttle axes assignment in P3D. 2 - A screenshot of the CRJ joystick interface in the EFB ? Thank you. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.