Jump to content

FLIGHT PLAN WON'T UPLOAD


Recommended Posts

  • 3 weeks later...
  • Aerosoft

Hello EmpireKicking,

You seem to be trying to enter the airport as a waypoint. Please try to enter the departure arrival pair on the INIT A page FROM/TO field.

I also recommend you to check vol2-NormalProcedures.pdf manual from the Documents section and try to perform a flight using exactly the procedures listed there :)

Link to comment
Share on other sites

I am using Navigraph and when I load any to\from into the MCDU I get the same message Not In Database. The aircraft is at KATL at the Gate F1 and set to turn around. I go by the checklist and when I try and enter a Fltplan KATL\KDEN the program says not in database. Any idea what is going on?

 

JeffG

Link to comment
Share on other sites

  • Deputy Sheriffs

Jeff,

there are two ways to load the F-PLAN in your case: Enter KATL/KDEN (and not KATL\KDEN) into the scratchpad and use LSK1R. If there are more than one plan existing with the same departure / arrival airport after loading you are able to change to the other ones by using the key "arrow pointing right". Another possibility is to enter KATLKDEN01 and then using LSK1R. If in both cases this is not working please send us a copy of the flight plan (maybe there are some format errors) and inform us on the exact location of the folders where your flight plans are saved as well as where the Aerosoft Airbus is located - like

- C:\Users\Rolf\Documents\Aerosoft\General\A3XX Flightplans

- E:\Aerosoft\Aerosoft A320-A321 Pro V5

 

Regards,

Rolf

 

Link to comment
Share on other sites

  • Deputy Sheriffs

What’s your Navigation Data Source(Setting in configurator)?

NavDataPro or Navigraph?

Which AIRAC are you running?

 

Please show us a screenshot of the configurator and one of the MCDU Status page (loaded at first entering  FMS or via DATA key, then STATUS)

Link to comment
Share on other sites

I am set up the config for the A330 and when I load I get the following pages, when I enter KATL/KDEN and push LSK1R it goes to a new page called NEW WAYPOINT> I am attaching the pictures

 

JeffG 

Aerosoft Config.jpg

MCDU1.jpg

MCDU2.jpg

MCDU3.jpg

Link to comment
Share on other sites

  • Deputy Sheriffs
On 2/17/2021 at 8:15 AM, masterhawk said:

Please show us a screenshot of the configurator and one of the MCDU Status page (loaded at first entering  FMS or via DATA key, then STATUS)

 

Link to comment
Share on other sites

  • Deputy Sheriffs
On 2/17/2021 at 4:30 AM, jeffg said:

My A330 Flightplan folder is C:\ Documents\Aerosoft\General\A3XX Flight plans

Just to make sure, that path should be:
C:\Users\YOUR_USERNAME\Documents\Aerosoft\General\A3XX Flightplans

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
 Share

×
×
  • Create New...