navyman 0 Posted November 22, 2020 Share Posted November 22, 2020 Hello Oliver, I am using FSX under windows 10 I have used AES for years with little or no trouble. However I wanted to install the LDS B767 aircraft and set up the parameters but I always get the disconnected error message in the red box. I tried a repeat of the exercise with a pmdg b7373 and had the same result. I have read on the forum about tring different approaches but nothing I try works can you please help regards Roy stevens Link to comment Share on other sites More sharing options...
Developer OPabst 2091 Posted November 22, 2020 Developer Share Posted November 22, 2020 You need to be on a AES active Airport to set the Parameters. And, try to start AESConfig direct instead to go via AEShelp, as the config tool must run in the same mode as the FSX, but AESHelp will always start in "As Administator" Mode, which my block the connection, when the FSX ist started normal. Link to comment Share on other sites More sharing options...
navyman 0 Posted November 22, 2020 Author Share Posted November 22, 2020 Hi Oliver, I started FSX from the FSX icon in the main FSX directory, loaded the a/c at eddn. I then started AES Config from the icon in the AES directory. AES displayed a yellow box and the following msg. Version Read Error AES Config connected, but could not read FS Version ID. Wait until FS is full up and Running and then try to restart AES Config. I waited for FS to be full up I then tried to restart AES Config but had the same result. Regards Roy Link to comment Share on other sites More sharing options...
Deputy Sheriffs mopperle 4162 Posted November 22, 2020 Deputy Sheriffs Share Posted November 22, 2020 AFAIK, you have to start both, AES and FSX, as Administrator (right click on the exe and choose "Run as....) Link to comment Share on other sites More sharing options...
Developer OPabst 2091 Posted November 22, 2020 Developer Share Posted November 22, 2020 Is EDDN as ON aktive in AESHelp? When no code is running of AES at the Airport you place the aircraft, the Massage is normal. Link to comment Share on other sites More sharing options...
navyman 0 Posted November 23, 2020 Author Share Posted November 23, 2020 Morning Oliver, I tried this morning, I made sure eddn is set ON and I started FSX as Administrator then started AES and yay! it worked, than you for support. Best Regards Roy Link to comment Share on other sites More sharing options...
Developer OPabst 2091 Posted November 23, 2020 Developer Share Posted November 23, 2020 Because we believe this topic has been answered we have closed it. If you have any more questions feel free to open a new topic. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.