Jump to content

Recommended Posts

Hi, during NPA I have the following issue. When I press trk button on FCU and I select the glide angle, I read FPA xx° on PFD - ok it's right. But as I pass through a previous displayed altitude in FCU (ie 3000 ft) the PFD indication changes to ALT●. I need to press for level off and select again the path angle to have back FPA xx°.  Is it a correct behaviour?  Thanks for comments about!

 

 

Link to post
Share on other sites
  • 2 weeks later...

For selected NPA don't press APPR, at 0.3 NM before the FAF set the desired flight path angle and PULL the knob. The aircraft will not level off at FCU altitude if you do this. Also make sure you have activated the approach phase in the FMGC before starting the approach.

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...