AlleUsai 0 Posted August 31, 2020 Share Posted August 31, 2020 Hi, yesterday i did a short ride from ENBR to ENVA using (as usual for me) ProATC-X. In flight plan the cruise flight level was 350 and I set this on MCDU. I was on CLIMB phase and everything with checklists was going fine. Before reaching FL350 ProATC (altitude was about 31000 feets) asked to descend to FL240. I did so but checklist was stuck on CLIMB phase so I did the rest of flight without CLs. Is it a normal behaviour or did I something wrong. I was not able to "reset" CL and start then BEFORE DESCENT one. I use P3D v4.5 HF3 and experimental version on Airbus Professional A320/A321. Thanks in advance, Alessandro Link to comment Share on other sites More sharing options...
Deputy Sheriffs mopperle 4162 Posted August 31, 2020 Deputy Sheriffs Share Posted August 31, 2020 Did you set the new ALT in the MCDU Init page A? Link to comment Share on other sites More sharing options...
AlleUsai 0 Posted August 31, 2020 Author Share Posted August 31, 2020 No, I didn't. Is mandatory to do it if the expected cruise altitude is never reached before starting descent phase? Alessandro Link to comment Share on other sites More sharing options...
Deputy Sheriffs mopperle 4162 Posted August 31, 2020 Deputy Sheriffs Share Posted August 31, 2020 Yes of course. as e.g. the flightpath and other stuff must be recalculated. Link to comment Share on other sites More sharing options...
AlleUsai 0 Posted August 31, 2020 Author Share Posted August 31, 2020 Ok Otto, it was my fault. Thanks a lot, Alessandro Link to comment Share on other sites More sharing options...
Deputy Sheriffs Secondator 643 Posted August 31, 2020 Deputy Sheriffs Share Posted August 31, 2020 Because we believe this topic has been answered we have closed it. If you have any more questions feel free to open a new topic. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.