Jump to content

tiller and twist axis


radeon29

Recommended Posts

1 hour ago, mopperle said:

have you assigned the tiller to the rudder axis?

this was assigned by default, this is convenient when we do not have a separate axis for the .

but this creates some problems when runway acceleration, tiller continues to work together with rudder...

it is useful to have the function of disconnecting the tiller from the rudder axis(twist axis) before runway acceleration.

 

p/s and sorry, I created this topic in the wrong topic, I have a 64 bit bus, if possible move this to the correct section.

Link to comment
Share on other sites

  • Deputy Sheriffs

usually pressing the PEDAL DISC button will disconnect the rudder from the nosewheel. This is described in the manual. Did you try it?

Link to comment
Share on other sites

1 hour ago, mopperle said:

the PEDAL DISC button

this button is pressed only once , after start checklist: flight controls( and after test we return button back) and no more pressing is required.

and if we press it, then we completely lose control of the nose gear, which is unacceptable during takeoff.

during runway acceleration, we must have

nosewheel range up to +/- 6 degrees turn,

and not as with an active tiller: nose wheel range up to +/- 75 degrees turn.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue. Privacy Policy & Terms of Use