Jump to content

COM 1 & 2 Dials


Sabretooth78

Recommended Posts

Since installing the latest full build (1.3.1.0) of the A320, I've noticed that the outer COM dials won't "turn over", i.e. when standby is set to 136.xx, dialing up on the outer dial will not cause the number to cycle over to 118; likewise I can't cycle down to 136 from 118.  The minor dial will roll over, i.e. 124.95 -> 125.00 -> 125.05 but again won't cycle past 136.xx or 118.xx.  I also seem to be seeing the 8.33 spacing, i.e. x.000 -> x.005 -> x.010, etc.; which I didn't see before this last update.

 

I did a quick search and didn't see that anybody else has reported this behavior.  Is it possible there is something I've done that could be causing this?

Link to comment
Share on other sites

In an attempt to root out a possible issue on my end, I reinstalled the buses (A318-21 and 330; with Windows virus protection turned off), repaired all the C++ libraries and ran the Netfx repair tool.  The issue still persists identical to as I reported it above.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue. Privacy Policy & Terms of Use