Jump to content

ZRH v1.1.0.1 Taxiway line missing


Olivier7

Recommended Posts

  • Deputy Sheriffs

Taxilines are all as they should be. Do you have anything ielse installed in that region that might interfere with LSZH? An yOrbx stuff for example.

Please login to display this image.

Link to comment
Share on other sites

I do have the very same issue on taxiway 'C' too. "Picture1" shows the position, where the taxiway 'C' disappears. Please note, that the taxiway within the red boundary can still be seen a little bit. In "Picture2" you can see, that the taxiway 'C' will disappear  until the end of the de-icing area. The taxi light housing, however, can still be seen during daytime.

 

I think, I didn't have this issue with P3D V4.1. I upgraded to P3D V4.5 lately and since then I notice this. As a result, I uninstalled the scenery and installed it again. But I still have the same issue.

 

Any thoughts what this could be?

 

Thank you

Adrian 

 

Please login to display this image.

Please login to display this image.

Link to comment
Share on other sites

  • Deputy Sheriffs

It may take a while, as the Projectmanager is out of the office till 20th April. So do not expect to happen anything before end of April.

Link to comment
Share on other sites

  • 1 month later...
  • Administrator

Hi Thomas,

 

this problem was fixed with the latest version of Zuerich for P3Dv5.

Please run the Aerosoft updater to up update the scenery.

 

best regards

Guenter Zehnel

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue. Privacy Policy & Terms of Use