Deputy Sheriffs Hanse 216 Posted January 10, 2020 Deputy Sheriffs Share Posted January 10, 2020 Hi, thanks for the indepth answer. But I still have a question: Are you just talking of the light itself on the plane or does the light on the surface p.e. when landing is not illuminating the ground? Regards, Rolf Link to comment Share on other sites More sharing options...
fungswat 1 Posted January 10, 2020 Share Posted January 10, 2020 54 minutes ago, Hanse said: Hi, thanks for the indepth answer. But I still have a question: Are you just talking of the light itself on the plane or does the light on the surface p.e. when landing is not illuminating the ground? Regards, Rolf Are you asking about the strobe? For strobe, it is not switch on no matter from overhead panel or exterior camera after before take-off checklist. It should switch on during the before take-off checklist, but negative here For landing light, the overhead panel showing switched on but the exterior observation doesn't switch on actually, no landing lights on after descending lower than FL100 Link to comment Share on other sites More sharing options...
Deputy Sheriffs Hanse 216 Posted January 11, 2020 Deputy Sheriffs Share Posted January 11, 2020 vor 15 Stunden , fungswat sagte: STROBE: It should switch on during the before take-off checklist, but negative here We use the AUTO setting according to the SOP we implemented. AUTO means that STROBES are going on automatically if the plane is airborne - based on the position of the shockabsorbers....... Regarding the LANDING LIGHTS you are right and we therefore put the issue on our list open items. Link to comment Share on other sites More sharing options...
fungswat 1 Posted January 11, 2020 Share Posted January 11, 2020 5 hours ago, Hanse said: We use the AUTO setting according to the SOP we implemented. AUTO means that STROBES are going on automatically if the plane is airborne - based on the position of the shockabsorbers....... Regarding the LANDING LIGHTS you are right and we therefore put the issue on our list open items. Understood for both strobe light and landing light issue and thanks a lot for this positive feedback Link to comment Share on other sites More sharing options...
Deputy Sheriffs Hanse 216 Posted January 16, 2020 Deputy Sheriffs Share Posted January 16, 2020 A new update 1.0.0.7 is available now which regarding the checklist and copilot solves the following issues: BEFORE ENGINE START CL: Starting issue in connection with GSX closing doors - solved - ECAM PAGES: Manually selected by CL are now reset to standard when next CL item is called CHRONO FO: Set ON when takeoff thrust is set and stopped after landing VC LIGHTS: When C&D as well as TO state is used VC-lights are automatically set to "flight" when TAXI CL is started LANDING LIGHTS: Were not really ON after descending below 10k feet even that OVHD switch was ON - solved BEFORE TAKEOFF - Landing Lights are now automatically switched on when plane enters the departure runway. I therefore will close this topic and ask you if there are still " checklist issues" to open a new thread. Regards, Rolf Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.