skwal 9 Posted December 22, 2019 Share Posted December 22, 2019 Hi, So my controller told me that runway is shortened therefore I will not have the full 3700m of runway, but only 2400. I've added 2400 into "TO Shift field" in [M] and nothing changed. I tried setting higher and lower values, to no avail, FLX and calculated speeds stayed the same.. Obviously with existing FLEX temp I will run out of runway, any ideas here? Is that field simulated? Regards, Link to comment Share on other sites More sharing options...
D.R. 1 Posted December 22, 2019 Share Posted December 22, 2019 I am not sure if simulated or not. Link to comment Share on other sites More sharing options...
Deputy Sheriffs masterhawk 799 Posted December 22, 2019 Deputy Sheriffs Share Posted December 22, 2019 The TO Shift should be the shift value, not the remaining runway. Have you just entered the shift, after the TOspeeds,flex was entered or prior setting TO perf? Link to comment Share on other sites More sharing options...
skwal 9 Posted December 22, 2019 Author Share Posted December 22, 2019 I did 2400, I did 3700-2400 value. I entered before TO FLEX was entered, I entered after TO FLEX was entered. Nothing changed. FLX stayed at 54 and speeds stayed the same. Link to comment Share on other sites More sharing options...
matty260191 23 Posted December 22, 2019 Share Posted December 22, 2019 maybe like in the smaller busses it does nothing. Link to comment Share on other sites More sharing options...
skwal 9 Posted December 23, 2019 Author Share Posted December 23, 2019 21 hours ago, matty260191 said: maybe like in the smaller busses it does nothing. So then its probably a gimmick feature. Link to comment Share on other sites More sharing options...
matty260191 23 Posted December 23, 2019 Share Posted December 23, 2019 yes for now maybe at some point they will implement it. you can enter to the box but i have never seen it change anything. Link to comment Share on other sites More sharing options...
skwal 9 Posted December 24, 2019 Author Share Posted December 24, 2019 54 minutes ago, matty260191 said: yes for now maybe at some point they will implement it. you can enter to the box but i have never seen it change anything. I'll manually subtract 5deg per every 100m of shortening Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.