phlpeo 98 Posted December 12, 2019 Share Posted December 12, 2019 When reaching cruise Altitude i was planning on going through all the ecam pages. Normally clicking the all button on the ecam page selection panel infront of the throttle will cycle through all the pages. However the a330 didn't not allow for this to happen. I can visit all pages by clicking the corresponding buttons but not the all button. Link to post Share on other sites
Deputy Sheriffs Secondator 225 Posted December 12, 2019 Deputy Sheriffs Share Posted December 12, 2019 Hello phlpeo, This feature is not currently modelled. We might look into modelling this feature later. Link to post Share on other sites
phlpeo 98 Posted December 12, 2019 Author Share Posted December 12, 2019 1 hour ago, Secondator said: Hello phlpeo, This feature is not currently modelled. We might look into modelling this feature later. it is a very basic feature tbh. one that should also be present on the a320 family. Link to post Share on other sites
Deputy Sheriffs masterhawk 693 Posted December 12, 2019 Deputy Sheriffs Share Posted December 12, 2019 11 minutes ago, phlpeo said: it is a very basic feature tbh. one that should also be present on the a320 family. Have you tried click and hold in the A320? Link to post Share on other sites
phlpeo 98 Posted December 12, 2019 Author Share Posted December 12, 2019 22 minutes ago, masterhawk said: Have you tried click and hold in the A320? i use the a320 from another dev that does simulate the feature. Link to post Share on other sites
Deputy Sheriffs masterhawk 693 Posted December 13, 2019 Deputy Sheriffs Share Posted December 13, 2019 21 hours ago, phlpeo said: i use the a320 from another dev that does simulate the feature. Sorry, that is not the answer to my question. FCOM: ...pressed and hold... So just do what I asked for. Click and hold. And it will cycle. It's modeld in both A320 and A330. Link to post Share on other sites
phlpeo 98 Posted December 13, 2019 Author Share Posted December 13, 2019 shows a thanks page instead of the ENG and then goes blank. and what is the interval rate that is modeled then? this should be rather rapid Link to post Share on other sites
Deputy Sheriffs masterhawk 693 Posted December 13, 2019 Deputy Sheriffs Share Posted December 13, 2019 10 hours ago, phlpeo said: shows a thanks page instead of the ENG and then goes blank. and what is the interval rate that is modeled then? this should be rather rapid The cycle is 3sec according FCOM. I tested it. No problem. Have you kept the mousepointer always at the ALL button, or did you move out the clickzone while you keep pressed? Link to post Share on other sites
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now