Ryan Spel 0 Posted December 9, 2019 Share Posted December 9, 2019 Good Evening All! First off, wow... This airplane is impressive at first glance and I am not off the gate as of yet. I am pref flighting right now to start a regional hop from CYYZ and when I go to initiate entering flight information, I enter CYYZ/KRSW and it asks me to enter the grid coordinates of KRSW as if the airport is not in the database, so I switched to KRSW/CYYZ and it wont acknowledge CYYZ in the system now but does admit that KRSW is there. Is this something anyone else is seeing? Link to comment Share on other sites More sharing options...
Urfin Valtum 1 Posted December 9, 2019 Share Posted December 9, 2019 Hi, I have the same problem Link to comment Share on other sites More sharing options...
Urfin Valtum 1 Posted December 10, 2019 Share Posted December 10, 2019 I solved this problem.In the Configurator you need to uncheck Navigraph and check NavDataPro.After that everything works Link to comment Share on other sites More sharing options...
jd4pm 5 Posted December 10, 2019 Share Posted December 10, 2019 Does this mean Navigraph will not work with A330? Link to comment Share on other sites More sharing options...
Aviator1985 210 Posted December 10, 2019 Share Posted December 10, 2019 I don't think so as navigraph works fine for me. My thoughts are the A330 ships with the navdata pro set and if you want to use navigraph you'd need to update it for the A3XX Link to comment Share on other sites More sharing options...
Bigt 83 Posted December 10, 2019 Share Posted December 10, 2019 If you are using Navigraph, then you need to make sure that option is checked in the configurator and then make sure you run your navdata installer so that aircraft has the latest database installed. I was having the same issue as the OP until I realized that I needed to install the navdatabase from Navigraph. Link to comment Share on other sites More sharing options...
Deputy Sheriffs mopperle 4162 Posted December 10, 2019 Deputy Sheriffs Share Posted December 10, 2019 And just to make it clear, the A330 uses the same navdatabase as the other buses. So in case you have Navigraph already installed for the A31x/A32x Pro, just swich it in the Configurator. Link to comment Share on other sites More sharing options...
Tommy Kevin Vevle 0 Posted December 10, 2019 Share Posted December 10, 2019 Also, on the initial FMGC page, you need to move the navigraph nav database from "second nav data base" to "active nav data base". This worked for me. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.