Mapping between TOWCG and THS Setting wrong in Fuel Planner as well as Step by Step Guide

[AMJBecker 0]

Apparently the mapping between the TOWCG values and and the THS settings are not correct in Fuel Planner as well as the Steb-byStep Guide. Chapter 5.4 in Vol 6 (Step-by-Step Guide) shows the mapping for A319, which in fact is that of the A321, and vice versa. The Fuel Planner seems to have taken over the same swap. Selecting e.g. A319, the TOWCG translates in THS settings for the A321, and vice versa.

 

This is the Trim Wheel for the A319, where the TOWCG value of 41 corresponds to DN 3:

Please login to display this image.

 

... and this is the picture in the Step-by-Step Guide:

Please login to display this image.

Here the TOWCG 41 of the A319 is higher than DN 3.

 

[Aerosoft Team [Inactive Account] 51558]

We;'ll have a look at that sir.

[masterhawk 799]

I have here the correct stripes direct from QRH:

 

Please login to display this image.

Please login to display this image.

Please login to display this image.

Please login to display this image.

I would say document wrong. Model/texture correct.

[AMJBecker 0]

Thanks! That's correct.

 

Did you also check the Fuel Planner?

[masterhawk 799]

On 12/10/2019 at 4:47 PM, AMJBecker said:

Thanks! That's correct.

 

Did you also check the Fuel Planner?

Fuel Planer was reworked during A330 development. With next update for A320 you should get one, that better use the different margins.