Jump to content

Fly the CRJ with joystick


ChrP

Recommended Posts

Hello,

 

I have difficulties to fly the CRJ with my joystick: Though I calibrated the stick and though I could not find any anomalies in flying other planes with it, the CRJ - though the joystick is in neutral Position - goes into a very high-angle climb flight which makes the plane stall after a short time. Is it supposed to be like that, or do I have to perform a special joystick calibation for the CRJ, or is there anything I am maybe doing wrong?

 

Regards

  Christoph

Link to comment
Share on other sites

It is always difficult to give advice when there is so little information.

 

No special joystick configuration is required for the CRJ.
I am using an old MS Forcefeedback2 joystick without any problems.


Questions:

Which joystick do you use ?
Which trim value have you set?

What were the weights in the CRJ-Manager (Scrennshot please)?

 

Wolfgang

Link to comment
Share on other sites

Hi,

 

I would also to know

  • which Simulator do you use? FSX or P3D?
  • Do you set up your joystick with your default FSX Settings or with FSUIPC?

 

I prefer the following solution for me:

 

Disable the Controller Management in P3D

  • Controls -> Other -> Enable Controller(s) -> Untick

Set up my Axis with the FSUIPC Axis configuration and "Send FSUIPC Axis" Settings and no FS AXIS settings

-> since this setup every problems like your's don't "catch" me again 😉

 

Good luck!

Link to comment
Share on other sites

6 hours ago, ChrP said:

I used the information in the tutorial flight document for setting up the elevator trim.

 

It could also be your PAX and Cargo loading.  Elevator trim only goes so far.

 

Try loading zero PAX, zero Cargo, and minimum fuel and see if you still have the issue?

 

 

Link to comment
Share on other sites

The joystick is Thrustmaster USB Joystick.

 

In my current test, the elevator trim is set to  6.6°. That is the value shown by Dave and I took that one; the value shown in the CRJ Manager is a little lower.  

 

My simulator is P3Dv4, the joystick calibration was within P3D.

 

> Try loading zero PAX, zero Cargo, and minimum fuel and see if you still have the issue?

 

The issue does not disappear with these values.

Please login to display this image.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue. Privacy Policy & Terms of Use