Hoffie3000 96 Posted October 8, 2019 Share Posted October 8, 2019 I have an unusual problem with version 1.2.5.0 or higher. Unfortunately I can only adjust the trim settings in steps of 0.8. It doesn't matter if + or - , for example -0.8, 0, +0.8, +1.6, +2.4 and so on. A new installation, with deletion also of the data under "Documents/Aerosoft/General", did not bring any improvement. The problem also exists in version 1.2.5.1. Are there any ideas to solve the problem? All other installed planes, no matter if default P3Dv4.5 or other addon planes, do not show this behavior. Wolfgang Please login to display this image. Link to comment Share on other sites More sharing options...
Aerosoft Aerosoft Team [Inactive Account] 51558 Posted October 8, 2019 Aerosoft Share Posted October 8, 2019 How do you set the trim? Link to comment Share on other sites More sharing options...
Hoffie3000 96 Posted October 8, 2019 Author Share Posted October 8, 2019 Via numpad keyboard only Wolfgang Link to comment Share on other sites More sharing options...
Deputy Sheriffs mopperle 4162 Posted October 8, 2019 Deputy Sheriffs Share Posted October 8, 2019 Use the mousewheel or mouse button only, then you can change it in increments of 0,1 Link to comment Share on other sites More sharing options...
Hoffie3000 96 Posted October 9, 2019 Author Share Posted October 9, 2019 Just tested and Mousewheel adjusts the trim wheel in 0.1 steps. In the version´s history I found no change and until 1.2.4.2 you could do it as usual with the keyboard. Well, good to know. Wolfgang Link to comment Share on other sites More sharing options...
Aerosoft Aerosoft Team [Inactive Account] 51558 Posted October 10, 2019 Aerosoft Share Posted October 10, 2019 I a not aware we ever changed this, in the internal logs I also do not see any change in this. Link to comment Share on other sites More sharing options...
atav757 19 Posted October 10, 2019 Share Posted October 10, 2019 I had this issue too, using a keyboard or similar, it increments way too quickly. Using a mousewheel or joystick wheel it's slower. Even with the same key command in P3D controls settings. This was a new issue for me too so something definitely changed. Link to comment Share on other sites More sharing options...
Aerosoft Aerosoft Team [Inactive Account] 51558 Posted October 11, 2019 Aerosoft Share Posted October 11, 2019 I'll ask the devs. uh wait, could it not be something changed in P3d V4.5? Link to comment Share on other sites More sharing options...
Aerosoft Aerosoft Team [Inactive Account] 51558 Posted October 11, 2019 Aerosoft Share Posted October 11, 2019 try playing with this... Please login to display this image. Link to comment Share on other sites More sharing options...
Hoffie3000 96 Posted October 11, 2019 Author Share Posted October 11, 2019 If there had been a general change in P3Dv4.5, all aircraft would have been affected. But they are not, as written above, only the Airbus is affected. All other airplanes can still be trimmed with the keyboard in 0.1 steps. You only have two entries if you put a trimming action on the joystick or a similar part in addition to the keyboard. I trim only with the keyboard and set the flaps only with the joystick, so I only have one entry at a time. Remark: I changed the keys Trim up and Trim down different from the original one Please login to display this image. Wolfgang Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.