gollum65 1 Posted August 22, 2019 Share Posted August 22, 2019 I've been flying the Aerosoft Bus Pro for months and this is the first time I've seen this happen. I was cruising along at FL310, about halfway between Gatwick and Naples, and all of a sudden the aircraft had a complete power failure. The batteries on the overhead indicated 28 volts each, but the APU wouldn't start and I had no way to power the aircraft back up. What I THINK happened is that during pre-flight I may have forgotten to initialize the load sheet? I don't remember for sure. So my guess is, if I didn't load the load sheet that I must have run out of fuel? Can anyone advise what fuel load the plane loads at by default? If it's the fuel and payload from the beginning of the last flight, the last time I loaded the load sheet, it would have had more than enough fuel as that was a 4 hour flight. Is it possible the aircraft loaded with the fuel that remained after that flight? That would certainly make sense. If I didn't run out of fuel, any ideas on what could have happened? Link to comment Share on other sites More sharing options...
djspatrick 15 Posted August 22, 2019 Share Posted August 22, 2019 Hi @gollum65, There's a sticky thread for this: You might want to post something in there.. Link to comment Share on other sites More sharing options...
gollum65 1 Posted August 22, 2019 Author Share Posted August 22, 2019 OK Thanks Link to comment Share on other sites More sharing options...
Deputy Sheriffs mopperle 4162 Posted August 22, 2019 Deputy Sheriffs Share Posted August 22, 2019 Because we believe this topic has been answered we have closed it. If you have any more questions feel free to open a new topic. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.