Recently we have seen a lot of codes used to unlock our products being offered for discounted prices. Almost all of them are bought using stolen credit cards. These codes will all be blocked by our systems and you will have to try to get your money back from the seller, we are unable to assist in these matters. Do be very careful when you see a deal that is almost too good to be true, it probably is too good to be true.

Jump to content
Godsholytrousers

Can't swap to cold and dark

Recommended Posts

Hi I'm trying to configure my airbus so that when I load up it starts up cold and dark.

 

I followed the instructions in the manual and it doesn't seem to indicate how to get to the menu in which you can swap the configuration on the first officers side (they both appear to the same page right now).

 

Has anyone else encountered this problem?

Share this post


Link to post

Well you really should carefully read the step-by-step guide, it is all explained in detail, especially chapter 1.1. and 4.3

Share this post


Link to post

Hi I followed the instructions especially the following section:

 

To use the CHECKLIST and the COPILOT function it is necessary to load one of the menu – states. You access this menu via the Settings MCDU Main Menu by selecting ACFT STATE. Please load COLD DARK STATE.
In real life most likely the maintenance would have prepared the aircraft already before the flight crew arrives, so TURN AROUND STATE could also be a realistic startup state. For this tutorial however please use COLD DARK.

 

But none of that is appearing on MCDU2, see the attached file.

 

I also referred to this video where the required menu appears to show up on the copilots side by default, which is not the case for me.

 

 

 

 

 

 

mcdu issue.png

Share this post


Link to post
vor 7 Stunden , Godsholytrousers sagte:

But none of that is appearing on MCDU2, see the attached file.

  

I also referred to this video where the required menu appears to show up on the copilots side by default, which is not the case for me.

 

The video is from a FSX flight.

Aerosoft Bus Professional (64 bit, P3D V4) is only for P3D V4+

 

So I guess you read the wrong manual (Aerosoft A320/A321)

 

You need the MCDU3 ( Key: Shift+4)

 

MCDU3.thumb.jpg.313ecdd5778f809c02e7a09d79deaa8b.jpg

 

 

Cheers

Thomas

Share this post


Link to post

@Godsholytrousers: I told you read the manual, nothing else and not watching outdated videos for another product. I even gave you the name of the documentation and the chapters.

Share this post


Link to post

Because we believe this topic has been answered we have closed it. If you have any more questions feel free to open a new topic.

Share this post


Link to post
Guest
This topic is now closed to further replies.

×
×
  • Create New...