Jump to content
Sign in to follow this  
Argonox

A320: Not possible to close right handed doors

Recommended Posts

Hi,

 

when both doors on the right side of the airplane are open, it is impossible to close both of them.

It is possible to close the right AFT door via the settings MCDU, but as soon as I press the button for the right FRONT door, the AFT door opens again, while the FRONT door closes and immidiately opens as well.

 

I don't have the problem with the A318/A319.

 

I expirienced this issue with P3D 4.4 AND 4.5. I did a FULL re-install with all add-ons of P3D when switching from 4.4 to 4.5.

I've installed the latest available version for the Aerosoft Airbuses.

 

Any advice how to fix this problem?

 

thx and br,

Sven

 

 


 

Share this post


Link to post
Share on other sites

At which state does this happen? Is there anything going on, like boarding/deboarding etc. ? Do you use GSX?

Share this post


Link to post
Share on other sites

Hello Mopperle,

 

yes, I am using GSX Level 2 (latest available version today).

I am usualy faced with the issue, after the catering trucks of GSX are done with their work and I want to close.

 

It is worth to mention that as soon as the catering trucks arrived at the plane, GSX opens both right handed doors. GSX shows continuously the message "Please open Exit 3".

 

Please also note, that a temporary deactivation and/or reset of GSX does not solve the issue (for me).

 

thanks for your support,

Sven

Share this post


Link to post
Share on other sites

Then something must be misconfigured at GSX. I'm also using it, and when GSX is finished, the doors close automatically. And I never get a message "Please open exit 3".

Are you using the lastest version 1.2.4.2 of the Airbus?

Share this post


Link to post
Share on other sites

Hi mopperle,

 

I installed the mentioned experimental version 1.2.4.2 and it seems to be working now. :)

I never did any gsx aircraft customizing but I also hit the "reset" button in the gsx aircraft customization screen... just to be sure, that nothing bad will remain behind the scenes. ;)

 

I think this issue is solved for me now. Thank you very much! :)

 

best regards,

Sven

Share this post


Link to post
Share on other sites

Because we believe this topic has been answered we have closed it. If you have any more questions feel free to open a new topic.

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

×
×
  • Create New...